Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Preparing the Locomotive
1.1 Determining the Auxiliary Functions.
Maximum load on the motor outputs:
800 milliamps
Maximum load on the function outputs:
150 milliamps
Maximum load for the complete decoder:
1.100 milliamps
➔ maximum of 1 smoke generator per function output
➔ maximum of 2 Telex couplers per function output
➔ maximum of 2 no. 610 080 (19 V) light bulbs or
1 no. 610 040 (16 V) light bulb per function output
1.2 Preparing / Installing the Motor
Step 1: Remove the brush plate, armature, field,
electronic circuit or reverse unit.
Note: Remove all interference suppression capacitors
on the motor! There can be no ground connection
from the motor through interference suppression
elements to the locomotive's frame!
Note for 60922: Do not disassemble the motor.
Just check the interference suppression elements!
Step 2: Check the gear train for wear and to make
sure it is free running.
Step 3: Install the new permanent magnet field,
armature, and brush plate.
Note for 60924: Select the appropriate brush plate
and armature. Difference in the armatures: pinion
gear with 7 or 8 teeth. Never install an armature with
the wrong pinion gear! Doing this can cause damage
to gears!
green
blue
7
Werbung
