Märklin 60903 Handbuch Seite 9

Switching the function outputs
The function connected to that part of the decoder
controlled by the "function" button can be switched
on and off in all Märklin Motorola Digital systems.
Pressing the "function"
button on the controller:
function on
Pressing the "off" button
on the controller:
function off
Up to 3 other functions can be switched when you
use the 6021 Control Unit.
Prerequisite: The switches for the mode of operati-
on that are located on the back of the Control Unit
must be set as follows:
1 2 3
off on off
4
off
Pressing the "f1" button
(or "f2") on the controller:
The optional users
connected to that part
of the decoder controlled
by "f1" (or "f2") are
turned on.
Pressing the button again
turns the function off.
Pressing the "f4" button
on the controller:
The acceleration/braking
delay that has been set
on the locomotive is
minimized.
Pressing the "f4" button
again restores the
acceleration/braking delay.
9