Märklin 78100 Handbuch Seite 19

Display distance covered / minimum speed /
maximum speed
In the display bottom right, either the distance
travelled on the static test roller stand is shown,
or the maximum or minimum speed achieved over
that distance. By pressing for a short time (less than
1 second) on the "Dist. min max" button, the display
is switched from one measurement variable to the
next each time. By pressing on the "Dist. min max"
button for longer (at least 2 seconds), the respective
measurement variable is reset. The distance travelled
value is reset to "0", and the speed display (whether
for min or max) is set to the measured value appli-
cable at that moment.
Only the scale of 1:87 is suitable for displaying
a minimum speed.
Scope of the display of distance travelled:
0 m – 999.9 m
1000 m – 9999 m
10.0 km – 999.9 km (distance < 1000 km)
1000 km – 9999 km (distance < 10000 km)
(distance < 1000 m)
(distance < 10000 m)
Note: If the locomotive was stopped following the
last time the minimum speed measurement was
reset, then naturally the meter displays the minimum
speed as "0". In that case, reset the value once the
locomotive is moving (press the "Dist. min max" but-
ton for a longer period) and then the desired value
can be determined with the locomotive constantly
being run.
19