Operating the device
Preliminary requirements: static roller test stand with
connected operating system and installed pair of rol-
lers connected to the meter. The locomotive model
must be positioned on the static roller test stand.
Switching the computer meter on/off
Pressing the "On/Off" button switches the device on.
Pressing this button again switches the device
off again.
16
All the steps listed below only function if the device
is switched on.
Setting the measurement
By pressing the "Scale" button, it is possible to set
different conversion factors. The value selected in
each case is shown in the display. The individual
values are selected one after another. At the end
of the table, the list of selection options returns to
the beginning.