Märklin 78158 Handbuch Seite 15

Display distance covered / minimum speed / maxi-
mum speed
In the display bottom right, either the distance travelled
on the static test roller stand is shown, or the maximum
or minimum speed achieved over that distance. By
pressing for a short time (less than 1 second) on the
"Dist. min max" button, the display is switched from
one measurement variable to the next each time. By
pressing on the "Dist. min max" button for longer (at
least 2 seconds), the respective measurement variable
is reset. The distance travelled value is reset to "0", and
the speed display (whether for min or max) is set to the
measured value applicable at that moment.
Only the scale of 1:87 is suitable for displaying a
minimum speed.
Scope of the display of distance travelled:
0 m — 999.9 m
1000 m — 9999 m
10.0 km — 999.9 m
1000 km — 9999 m
(distance < 1000 m)
(distance < 10000 m)
(distance < 1000 km)
(distance < 10000 km)
Note:
If the locomotive was stopped following the last time
the minimum speed measurement was reset, then na-
turally the meter displays the minimum speed as "0".
In that case, reset the value once the locomotive is
moving (press the "Dist. min max" button for a longer
period) and then the desired value can be determined
with the locomotive constantly being run.
15