Introduction; Intended Use; Depicted Components; Package Contents - Parkside PBH 1050 B2 Bedienungsanleitung

HAMMER DRILL PBH 1050 B2

Introduction

Congratulations on the purchase of your new
appliance. You have chosen a high-quality product.
The operating instructions are part of this product.
They contain important information about safety,
usage and disposal. Before using the product, please
familiarise yourself with all operating and safety in-
structions. Use the product only as described and for
the range of applications specified. Please also pass
these operating instructions on to any future owner.

Intended use

The PBH 1050 B2 hammer drill and power chisel
(hereinafter referred to as appliance) is suitable for:
▯ Hammer-drilling into brickwork, concrete and stone
▯ Chiselling into concrete, stone and plaster
▯ Drilling into stone, wood and metal
Any other usage or modification of the appliance
is deemed to be improper and carries a significant
risk of accidents.
The manufacturer accepts no responsibility for
damage(s) attributable to misuse. The appliance
is not intended for commercial use.

Depicted components

Wing screw
Clockwise/anticlockwise switch
ON/OFF switch
Speed preselector wheel
Locking button for ON/OFF switch
LED
Function selector
Release button for function selector switch
Additional handle
Dust protection cap
Tool holder
Locking collar
Depth stop (not prefitted)
Quick-release chuck
│ GB │ IE
■ 12

Package contents

1 hammer drill PBH 1050 B2
1 additional handle
1 quick-release chuck with SDS plus system tool
fitting (see fig. A)
3 SDS drills (6/8/10 x 150 mm) (see fig. B)
1 flat chisel (14 x 250 mm) (see fig. B)
1 pointed chisel (14 x 250 mm) (see fig. B)
1 depth stop
50 g special grease for lubricating the drill chuck
1 carrying case
1 set of operating instructions

Technical data

Rated power
consumption:
Rated voltage:
Rated idling speed:
Stroke rate:
Impact energy:
Max. drill diameter:
Protection class:
Noise emission value:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level
of the power tool is typically as follows:
Hammer drilling:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Chiselling:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Wear hearing protection!
1050 W
230 V ∼ 50 Hz
(AC)
n 0–980 rpm
0
0–5300 rpm
3 J
13 mm for steel
32 mm for wood
26 mm for concrete
II / (double insulation)
L = 83.66 dB(A)
pA
3 dB
L = 94.66 dB(A)
WA
3 dB
L = 90.62 dB(A)
pA
3 dB
L = 101.62 dB(A)
WA
3 dB
PBH 1050 B2