Troubleshooting; Hints On Disposal; Declaration Of Conformity - Klarstein 10029351 Bedienungsanleitung

Problem
Appliance dose
not work.
Appliance freezes
too much.
The food is not
frozen enough.
Heavy build-up of
frost on the door
seal.
Unusual noises.
According to the European waste regulation 2002/96/EC this symbol on the product
or on its packaging indicates that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product. For more de-
tailed information about recycling of this product, please contact your local council or your
household waste disposal service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
643/2009/EC (ErP)
1060/2010/EU (ErP)
11

Troubleshooting

Possible Cause
Mains plug is not plugged in.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold or the
appliance runs at "7" setting.
Temperature is not adjusted.
Door was open for an long period. Open the door only as long as necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Appliance is near a heat source.
Door seal is not air-tight.
Appliance is not level.
The appliance is touching the wall
or other objects.
A component inside is touching
another part of the appliance.

Hints on Disposal

Declaration of Conformity

Solution
Insert mains plug.
Check fuse, replace if necessary.
Malfunctions are to be corrected by an electrician.
Turn the temperature regulator to a warmer setting
temporarily.
Look in the initial Temperature Setting section.
Turn the temperature regulation to a colder
setting temporarily.
Look in the installation location section.
Carefully warm the leaking sections of the door
seal with a hair dryer (on a cool setting). At the
same time shape the warm.
Check the appliance and level it.
Move the appliance slightly.
Carefully bend the component out of the way.