STIEBEL ELTRON DHE Touch 18/21/24 Bedienung Und Installation Seite 93

INSTALLATION
Installation options
f Fit a suitable pressure tap. f
f Push the lower back panel section under the connecting f
pipes of the tap and push it into the back panel.
f Secure the connection pipes to the tee and the 3-way ball f
shut-off valve.
Note
You can break off the pipe fitting tabs on the lower back
panel section if required.
1
1 Tab
13.7 Water installation on finished walls with
solder/compression fittings
You can connect copper or plastic pipes using the accessories
"solder fitting" or "press-fit fitting".
With "solder fitting" with threaded connection for 12 mm copper
pipes, proceed as follows:
f Push the union nuts over the connection pipes. f
f Solder the inserts to the copper pipes. f
www.stiebel-eltron.com
f Push the lower back panel section under the connecting f
pipes of the tap and push it into the back panel.
f Secure the connection pipes to the tee and the 3-way ball f
shut-off valve.
Note
Observe the tap manufacturer's instructions.
13.8 Fitting appliance cover over water installation
on finished walls
4
3
2
1
1 Back panel guides
2 Screw
3 Cover guide pieces with sealing lips on the pipe side
4 Pipe knock-outs
f Cleanly saw and break out the pipe knock-outs in the appli- f
ance cover. If necessary, use a file.
DHE Connect | DHE Touch | 93