Herunterladen Inhalt Inhalt Diese Seite drucken

Before Use; Connecting The Compressed Air Supply; Filling The Magazine; Operation - Parkside PDT 40 D3 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 49

Before use

NOTE
Put on the supplied protective goggles before
each use. Remove the protective film from the
goggle lenses before first use.

Connecting the compressed air supply

NOTE
In order to achieve the full power available
from your compressed air tool, always use
compressed air hoses with an internal diame-
ter of at least 9 mm. A lower internal diameter
can considerably reduce the power.
The appliance may be operated only with
cleaned, atomised-oil air and must not exceed
the maximum working pressure of 8 bar on
the appliance. The compressor must be fitted
with a pressure reducer to regulate the
working pressure.
CAUTION!
Do not use a compressed air line that contains
any condensate.
The tool must be sufficiently supplied with
pneumatic oil to ensure long service life. This
can take place as follows:
Use oiled compressed air by fitting a mist
lubricator.
Without a mist lubricator: Add oil manu-
ally via the threaded nipple
day. Approx. 1–2 drops of pneumatic
oil for every 15 operating minutes during
continuous use.
If the tool has been out of operation for sev-
eral days, add around 5 drops of pneumatic
oil manually via the threaded nipple
Connect the appliance to a suitable compressed
air source.
1.) For this purpose, press the quick-release
connection of the compressed air hose (not
included) onto the ¼" threaded nipple
of the compressed air stapler.
The connection locks automatically.
40
 │ GB│MT
2.) Now connect the other end of the com-
pressed air hose to the (filter) pressure
reducer on the compressor.

Filling the magazine

Press the magazine lever
magazine cover until it stops.
Place the appropriate fastener material (nails,
see fig. B or staples, see fig. C) in the magazine
. The staples must be placed on the bar of
the magazine
Slide the magazine cover forwards until it clicks
into place.

Operation

Load the magazine
stapler, as described in the section "Filling the
magazine".
Set the correct working pressure using the
pressure reducing valve (not supplied).
NOTE
Make sure that you do not exceed the
maximum working pressure of 8 bar on the
appliance. An excessive working pressure
does not mean increased output; it merely
increases the compressed air consumption
and accelerates appliance wear.
Switch on the compressor.
Run the compressor once until the maximum
every
tank pressure has been reached and then
switch off the appliance.
Place the appliance on the workpiece and pull
the trigger
NOTE
.
the appliance until the opening
compressed air stapler is pressed against the
workpiece and the trigger
and pull back the
.
of the compressed air
.
The compressed air stapler is
equipped with a trigger lock
The fastener material does not leave
is pressed.
.
of the
PDT 40 D3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis