Connecting To Your Amplifier; Standard Connections - Yamaha NS-F350 Bedienungsanleitung

You need a commercially available speaker cable.
This speaker system is capable of standard connections and bi-wire connection.
Before making connections, make sure that the amplifier is switched off.
■ Connections
Connect one speaker to the left (marked L) terminals of your amplifier or receiver, and another speaker to the right
(marked R) terminals. Please refer to the owner's manual that came with your amplifier or receiver.
Note
• Make sure you connect the speakers with the correct polarity—positive (+) terminals to positive (+) terminals, and
negative (–) terminals to negative (–) terminals. If you get them crossed over, the sound will be unnatural and lack bass.
• In your AV receiver's speaker size settings, specify small (or "S") for all of the speakers.
• The speaker may be damaged if certain sounds are continuously output at high volume level. For example, if sine waves
from a test disc, bass sounds from electronic instruments, etc., are continuously output, or when the stylus of a turntable
touches the surface of a disc, reduce the volume level to prevent the speaker from being damaged.
• Once you have connected all of the speakers, plug the amplifier and other AV components into suitable AC wall outlets.
• When using an amplifier with a rated output power higher than the nominal input power of the speaker, care should be
taken never to exceed the speaker's maximum input.
■ How to connect the speaker cables
15 mm
(5/8")
Good No Good
Note
• Make sure the terminal is gripping the bare wire, not the insulation.
• Make sure the bare wires do not touch each other, as this could damage the speaker or amplifier.
• If the connections are faulty, you will hear no sound from the speakers.

Standard connections

Loosen
Short bar
Black (–)
Negative (–)
Leave the short bars in place when connecting.
Connect the + speaker cable to the upper red terminal
and then – speaker cable to the lower black terminal.
2
En

Connecting to your amplifier

1
Remove 15 mm (5/8") of insulation from each end of the cables,
and twist the exposed conductors together neatly and tightly, as
shown left.
2
Loosen the terminal knob.
3
Insert the bare wire.
4
Tighten the knob and secure the cable.
5
Test the firmness of the connection by pulling lightly on the cable
at the terminal.
Tighten
Red (+)
Positive (+)
NS-F350/NS-F330
Right
SPEAKERS
R
L
A
– – +
+
B
Speakers output terminals
Left
Amplifier or
Receiver