Preparing The Product For Use; Unpacking; Safely Disposing Of Packaging Material; Assembly - Videotec GEKO IRN Bedienungsanleitung

5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

5.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Illuminator with bracket
• Wall-fastening bracket
• Bolts and screws
• Instruction manual
5.3 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
6

6 Assembly

Fasten the top bracket (01) to the illuminator using
the screws and washers (02) supplied.
02
Fig. 3

7 Installation

7.1 Installation of wall-mounted
illuminator
The illuminator's position can be decided at
the time of installation.
Fig. 4
Fasten the bracket as shown in the figure. Drive the
wall screws in tight.
Fig. 5
02
01
MNVCIRN_1828_EN