Safety Warnings - Märklin 16075 Gebrauchsanleitung

Function
This locomotive has a built-in multi-train electronic
circuit and offers these features:
• Optional operation with DC power (max. ± 18 volts DC),
AC power (with Märklin 32 VA transformer) Changeover
with the switch on the bottom of the Rail Zeppelin, page 8.
With Märklin Delta (only with the 6607 Delta Station), Mär-
klin Digital (only with the Control Unit), or Märklin Systems
(Mobile Station, Central Station).
• The mode of operation is automatically recognized.
• 80 multi-train addresses can be set.
• Adjustable acceleration (ABV).
• Adjustable Braking delay (ABV)
• Adjustable maximum speed.
• Headlights/marker lights/interior lighting continuously on
• The model is designed for operation on Märklin 1 Gauge
track. As the consumer you assume the risk for operating
on other makes of track.
• Minimum radius for operation: 1020 mm / 40-1/6".
Maintenance procedures that become necessary with normal
operation of the locomotive are described below. Please see your
authorized Märklin dealer for repairs or spare parts.
No warranty or damage claims shall be accepted in those cases where parts
neither manufactured nor approved by Märklin have been installed in Märklin
products or where Märklin products have been converted in such a way that
the non-Märklin parts or the conversion were causal to the defects and / or
damage arising. The burden of presenting evidence and the burden of proof
thereof, that the installation of non-Märklin parts or the conversion in or of
Märklin products was not causal to the defects and / or damage arising, is
borne by the person and / or company responsible for the installation and /
or conversion, or by the customer.

Safety Warnings

• This locomotive is to be used only with an operating
system designed for it (Märklin 6646/6647 AC transformer,
Märklin Delta, Märklin Digital or Märklin Systems).
Under no circumstances should transformers rated for an
input of 220 volts be connected to the American 110 volt
household current system.
• This locomotive must never be supplied with power from
more than one transformer.
• Pay close attention to the safety warnings in the instructions
for your operating system.
• Caution: Never grasp in the propeller with your fingers. You
may possibly pinch and injure your fingers!
• The feeder track must be equipped to prevent interference
with radio and television reception, when the powered
rail car is to be run in conventional operation. The 104770
interference suppression set is to be used for this purpose.
The interference suppression set is not suitable for digital
operation.
5
Betrieb • Operation • Fonctionnement • Exploitatie