Installation And Connection - Beko MGB 25332 BG Bedienungsanleitung

3

Installation and connection

3.1 Installation and
connection
• Remove all packing material and accessories.
Examine the oven for any damage such as
dents or broken door. Do not install if oven is
damaged.
• Remove any protective film found on the
microwave oven cabinet surface.
• Do not remove the light brown Mica cover that
is attached to the oven cavity to protect the
magnetron.
• This appliance has been designed for domestic
use only.
• This oven is intended for built-in use only. It
is not intended for counter-top use or for use
inside a cabinet.
• Please observe the special installation
instructions.
• The appliance can be installed in a 60cm wide
wall-mounted cabinet (at least 50 cm deep and
85 cm off the floor).
• The appliance is fitted with a plug and must
only be connected to a properly installed
grounded socket.
• The mains voltage must correspond to the
voltage specified on the rating plate.
• If the plug is no longer accessible after
installation, an all-pole isolating switch must be
present on the installation side with a contact
gap of at least 3 mm.
• Adapters, multi-way sockets and extension
cords must not be used. Overloading can result
with a risk of fire.
The accessible surface may be hot
during operation.
C
Do not trap or bend the power ca-
ble.
12 / 371 EN
Microwave Oven / User Manual