Adjusting The Base - Invacare Stand Assist Rps350–1Fr Gebrauchsanweisung

Invacare® Stand Assist

8.6 Adjusting the Base

The base A adjustment should not require any attention
other than adjusting the linkage rods.
Damage to the lift may occur.
– The legs must be in the fully closed position
before adjusting the linkage rods.
40
1. Close the legs all the way. Refer to 4.2.1 Closing/Opening
Manual Legs, page 17.
2. Check the squareness of the legs B when in the closed
position.
3. Place a square C on the inside of the legs and base to
determine the 90° alignment D.
4. Adjust the linkage rods E until 90° alignment is
achieved.
Damage to the lift may occur.
– DO NOT adjust the linkage rods so the legs are
at less than 90° alignment.
1078985-I