Installing The Shifter Handle; Attaching The Battery Charger Mounting Bracket To The Wall - Invacare Stand Assist Rps350–1Fr Gebrauchsanweisung

3.4 Installing the Shifter Handle

A Shifter Handle
1. Remove the shifter handle from the packaging carton.
2. Thread the shifter handle onto the male adapter on
the base.
1078985-I
B Male Adapter in Base
3.5 Attaching the Battery Charger Mounting
Bracket to the Wall
Refer to your local regulations concerning proper
mounting procedures.
This procedure only applies to RPS350–1E models.
1. Place the battery charger with mounting bracket A on
the wall at the desired position.
2. With a pencil, mark the middle hole B position.
3. Measure down 6½ inches (16.5 cm) from the pencil
mark and drill one mounting hole.
4. Install the bottom mounting screw C until there is an
approximate 1/8-inch (3 mm) gap between the screw
head and the wall.
5. Install the battery charger with mounting bracket onto
the bottom mounting screw.
6. Drill the remaining two mounting holes.
Setup
15