Herunterladen Inhalt Inhalt Diese Seite drucken

Pioneer PDP-50MXE1 Bedienungsanleitung Seite 22

Plasma display
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

System Settings
[CLAMP POSITION] setup
Depending on the signal, analog RGB signals may result
in the screen image appearing with a whitish or greenish
cast. In such cases, set [CLAMP POSITION] to [LOCKED].
Normally, leave this setting at [AUTO].
MENU
5/∞
2/3
SET
Main unit operating
Remote control unit
panel
1
Press the MENU button to display the menu
screen.
MENU
PICTURE
SCREEN
:
CONTRAST
:
BRIGHTNESS
:
R.LEVEL
:
G.LEVEL
:
B.LEVEL
:
H.ENHANCE
:
V.ENHANCE
PICTURE RESET
ENTER
SET
2
Use the 2/3 buttons to select [SETUP].
MENU
PICTURE
SCREEN
POWER MANAGEMENT
CLAMP POSITION
SIGNAL FORMAT
CHANGE
SET
18
En
MENU
2/3
SET
5/∞
INPUT1
SETUP
OPTION
0
0
0
0
0
0
0
EXIT
MENU
INPUT1
SETUP
OPTION
:
OFF
:
AUTO
: V G A
:
EXIT
MENU
3
Use the 5/∞ buttons to select [CLAMP POSITION].
MENU
PICTURE
SCREEN
POWER MANAGEMENT
CLAMP POSITION
SIGNAL FORMAT
CHANGE
SET
4
Press the SET button to select [LOCKED].
The factory default setting is [AUTO].
Mode selection will change as follows each time the
SET button is pressed:
3 AUTO
LOCKED 2
5
When the setup is completed, press the MENU
button to exit the menu screen.
Notes
÷ The [CLAMP POSITION] setting is supported only for INPUT1.
÷ When making this setting, be sure to confirm the signal output
of the component used. For details, consult the component's
Operating Instructions.
INPUT1
SETUP
OPTION
:
OFF
:
AUTO
:
V G A
EXIT
MENU

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis