Installation And Connection - Beko MGB 25332 BG Bedienungsanleitung

3

Installation and connection

3.1 Installation and
connection
• Remove all packing material and accessories.
Examine the oven for any damage such as dents
or broken door. Do not install if oven is damaged.
• Remove any protective film found on the micro-
wave oven cabinet surface.
• Do not remove the light brown Mica cover that
is attached to the oven cavity to protect the
magnetron.
• This appliance has been designed for domestic
use only.
• This oven is intended for built-in use only. It is
not intended for counter-top use or for use in-
side a cabinet.
• Please observe the special installation instruc-
tions.
• The appliance can be installed in a 60cm wide
wall-mounted cabinet (at least 55 cm deep and
85 cm off the floor).
• The appliance is fitted with a plug and must only
be connected to a properly installed grounded
socket.
• The mains voltage must correspond to the vol-
tage specified on the rating plate.
• If the plug is no longer accessible after instal-
lation, an all-pole isolating switch must be pre-
sent on the installation side with a contact gap
of at least 3 mm.
• Adapters, multi-way sockets and extension
cords must not be used. Overloading can result
with a risk of fire.
The accessible surface may be hot
during operation.
C
Do not trap or bend the power cable.
Microwave Oven / User Manual
13 / 371 EN