Accessories; Use And Operation - Klarstein 10013323 Handbuch

ACCESSORIES

Water Inlet Tube
Sealing Washer

USE AND OPERATION

1 Unpack the Ice Baby from it's carton, then remove the ice scoop, inlet/outlet tubes
and sealing washers from the container in the icemaker where they are stored for
transit.
2 Position the Ice Baby in a well ventilated place, leaving at least a 150 mm gap
between the ice maker and the walls/ceiling etc. The icemaker must be level, and
situated away from any heat source.
3 Attach one end of the 14mm flexible plastic corrugated pipe to the water outlet on
the back of the machine. The other end of the pipe should be inserted into a waste
pipe or a suitable container for the collection of the waste water.
4 Connect the 3/4" water inlet hose supplied with the ice maker to a drinking water
supply and then connect the other end to the water inlet on the back of the machine.
When connecting this hose, use the sealing washers supplied with the Ice Baby to
eliminate the risk of a water leak.
Note: The minimum inlet water pressure is 1.5 bar. The maximum inlet water pressure
is 5 bar.
Water Drainage Pipe
Ice Spoon
EN
15