Pioneer DDJ-SP1 Bedienungsanleitung Seite 8

Setting preferences
Name of selected item
Sampler velocity mode velocity
1
curve selection
Sampler velocity mode after-
2
touch setting
Setting of method to enter
sampler velocity mode
Setting of DJ software to be used
3
Demo mode setting
4
Setting of slip mode flashing
Setting of illumination when
tracks are loaded
5
Advanced MIDI settings
"*" indicates the default setting.
1 For details of the characteristics of the respective velocity curves, see this unit's Operating Instructions (Advanced Edition).
2 When after-touch is enabled, the sampler volume changes while the performance pad is being pressed according to the strength with which the pad is pressed.
3 The demo mode is a function by which a demonstration using this unit's illumination is conducted if no operation is performed for 10 minutes under normal usage
conditions.
4 When slip mode flashing is enabled, the buttons and controls that can be operated in the slip mode (the [AUTO LOOP] control, [HOT CUE] mode button, etc.) flash when
the [SLIP] button is pressed.
For the slip functions that can be operated with this unit, see this unit's Operating Instructions (Advanced Edition).
5 For details about the advanced MIDI settings, see this unit's Operating Instructions (Advanced Edition).
— To control Serato Video, disable the advanced MIDI settings.
2 Press the performance pad on the left side.
This selects the parameter or turns the parameter on and off.
! When this turns the parameter on and off, the parameter turns on and off each time pad 1 is pressed. When on, pad 1 is lit.
! To select a parameter from among multiple parameters, select and press one of the lit pads. The pad that was pressed flashes.
Saving the changed parameters on this unit
1 Press the rotary selector.
This saves the parameters that have been set in this unit's memory.
While the parameters are being saved, the eight buttons in the effect section flash. Do not disconnect the USB cable from this unit during this time.
2 Press the [BACK] button.
This unit switches from the utilities mode back to normal operation.
8
En
Flashing button Parameter
Pad 1: Curve 1*
FX1 effect parameter 1 button Pad 2: Curve 2
([A] on diagram) Pad 3: Curve 3
Pad 4: Curve 4
FX1 effect parameter 2 button Pad 1: After-touch disabled*
([B] on diagram) Pad 2: After-touch enabled
FX1 effect parameter 3 button Pad 1: Switch to sampler velocity mode when [SHIFT] + [SAMPLER] buttons are pressed*
([C] on diagram) Pad 2: Switch to sampler velocity mode when [SAMPLER] button is pressed for over 1 second.
FX1 [TAP] button ([D] on Pad 1 lit: Software other than Serato DJ used
diagram) Pad 1 off: Serato DJ used*
FX2 effect parameter 1 button Pad 1 lit: Turns demo mode on*
([E] on diagram) Pad 1 off: Turns demo mode off
FX2 effect parameter 2 button Pad 1: Slip mode flashing enabled*
([F] on diagram) Pad 2: Slip mode flashing disabled
FX2 effect parameter 3 button Pad 1: Illumination type 1*
([G] on diagram) Pad 2: Illumination type 2
FX2 [TAP] button ([H] on Pad 1: Advanced MIDI settings disabled*
diagram) Pad 2: Advanced MIDI settings enabled
Example ： Setting items for which 1 parameter is selected
HOT CUE
HOT LOOP
1
IN
5
ROLL SLICER SAMPLER
AUTO LOOP MANUAL LOOP VELOCITY
LOOP ACTIVE SAVE SLOT
2 3
OUT RELOOP / EXIT SLOT
6 7
4
8