Herunterladen Inhalt Inhalt Diese Seite drucken

Sharpening Knives; Sharpening Scissors; Change Grinding Disc - Parkside SHARPENING Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 79
GB
(10).
9. Repeat the sharpening process
until all irregularities have been
removed.
10. Switch the device off and wait for
the grinding wheel (10) to stop.

Sharpening knives

1. Mount the selected sharpener
(see Mounting sharpener).
2. Insert the blade of the knife right
into the knife sharpening slot.
3. Using light pressing guide the
blade along the grinding wheel
(10) and evenly and slowly pull
the knife towards you.
4. Turn the knife and insert the knife
blade into the opposite knife
sharpening slot.
5. Repeat this grinding process for
this side of the blade as well.
6. Execute the alternating grinding
process until the cutting edge is
burr-free and sharp.
7. Switch the device off and wait for
the grinding wheel (10) to stop.
The device is not suitable for grind-
ing serrated knives.

Sharpening scissors

1. Mount the selected sharpener
(see Mounting sharpener).
2. Completely open the scissors.
3. Insert the scissor blades into the
scissor sharpening slot.
4. Using light pressure guide the
blade from the screw up to the tip
along the grinding wheel (10).
5. Remove the scissors from the
sharpening station and turn the
12
scissors to sharpen the other
blade.
6. Insert the other scissor blade into
the scissor sharpening slot.
7. Using light pressure guide the
blade from the screw up to the tip
along the grinding wheel (10).
8. Execute the alternating grinding
process until the cutting edges
are burr-free and sharp.
9. Switch the device off and wait for
the grinding wheel (10) to stop.
The device is not suitable for grind-
ing serrated scissors. The device
is not suitable for grinding pinking
shears.

Change grinding disc

Information on replace-
ment:
• Never operate the device without
protective equipment.
• Ensure that the grinding disc
dimensions match those of the
device.
• Never use separate bushings or
adapters in order to make grind-
ing discs whose hole is too large
fit the device.
• Do not use any saw blades.
• Always reassemble the device
completely after replacing the
grinding disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
When the grinding disc nut (16) is
being tightened or loosened, the
axle has to be held firmly in place

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis