Part Names And Functions; Top Panel - Pioneer PLX-1000-N Bedienungsanleitung

Part names and functions

Top panel

n
1
2
1 POWER switch
When turning the switch to the [ON] side, the power is turned on and
the strobe illuminator on the side lights.
Playback (p. 12 )
2 START/STOP button
Pressing the button starts or stops rotation of the turntable.
Playback (p. 12 )
3 Speed change button
Changes the speed according to the record to be played.
For a 33 1/3 rpm record, press the [33] button.
For a 45 rpm record, press the [45] button.
Playback (p. 12 )
4 Stylus illuminator
Lights to illuminate the stylus tip.
Playback (p. 12 )
5 Stylus illuminator switch
The stylus illuminator lights in white and ascends to the position at
which the stylus tip is illuminated.
Playback (p. 12 )
6 Headshell
Used with a cartridge attached.
7 RESET button
8 RESET indicator
Pressing the [RESET] button turns on the [RESET] indicator. While
the [RESET] indicator is on, the turntable turns at the specified rota-
tion speed (33 1/3 rpm or 45 rpm) regardless of the position of the
TEMPO slider.
Adjusting the pitch (p. 13 )
6
En
3 4 5
m l k
6 7
9 TEMPO slider
You can slide back and forth to perform fine adjustment of the rota-
tion speed.
Adjusting the pitch (p. 13 )
a Tone arm
Adjustment (p. 8 )
b TEMPO RANGE button
Each time the button is pressed the tempo range switches, to ±8 %,
±16 %, or ±50 %.
Adjusting the pitch (p. 13 )
c TEMPO RANGE indicator
The set tempo range lights in blue.
d Arm clamper
Clamps the tone arm.
e Arm rest
Serves as the support base for the tone arm.
f Lifter lever
The tone arm goes up when the lever is pulled up. The tone arm goes
down when the lever is pushed down.
g Arm lifter
This device is used to move the tone arm up and down. It is operated
by the lifter lever.
h ANTI SKATING dial
When a record is played, there is power to pull the stylus tip toward
the inner perimeter. By matching this dial to the stylus pressure
value, that power is eliminated.
Adjusting anti-skating (p. 8 )
j
i
h
g
f
c
e d
b
a
9
8