Safety Instructions For All Applications - Parkside PWS 125 C3 Originalbetriebsanleitung

changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentaIly.
• Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of un-
trained users.
• Maintain power tools. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have the
power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
• Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working con-
ditions and the work to be per-
formed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
Service:
• Have your power tool serviced
by a qualified repair person
using only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Safety instructions for all
applications
Common safety instructions for
grinding, sanding, working with
wire brushes polishing and cutting
grinders:
• This electric tool is to be used as
a grinder, sander, wire brush,
polisher and cutting grinder.
Follow all safety instructions,
directives, illustrations and facts
which you receive with the de-
vice. If you do not follow these instruc-
tions, an electrical shock, fire and/or
serious injury may occur.
• Do not use any accessories that
are not specifically intended and
recommended for this electric
tool by the manufacturer. Simply
because an accessory can be attached
to your electric tool does not guarantee
safe operation.
• The allowable rotation speed
of the attachment tools must be
at least as high as the highest
rotation speed indicated on the
electric tool. Accessories that run fas-
ter than the allowable speed can break
and fly apart.
• The outside diameter and thick-
ness of the attachment tool must
correspond to the dimensions
indicated for your electric tool.
Attachment tools which are wrongly
dimensioned cannot be sufficiently
shielded or controlled.
• Attachment tools with threaded
attachment must fit the threa-
ding of the grinding spindle
exactly. For attachment tools
which are mounted through a
flange, the diameter of the hole
G B
9