Dell PowerConnect 7024 Handbuch Zum Einstieg Seite 295

with normal operation using the default system
configuration. Note: You can exit the setup wizard at
any point by entering [ctrl+z].
Would you like to run the setup wizard (you must
answer this question within 60 seconds)? [Y/N] y
Step 1:
The system is not setup for SNMP management by
default. To manage the switch using SNMP (required for
Dell Network Manager) you can
. Set up the initial SNMP version 2 account now.
. Return later and setup other SNMP accounts. (For
more information on setting up an SNMP version 1 or
3 account, see the user documentation).
Would you like to setup the SNMP management interface
now? [Y/N] y
To setup the SNMP management account you must specify
the management system IP address and the "community
string" or password that the particular management
system uses to access the switch. The wizard
automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell
Network Manager or other management interfaces to
change this setting, and to add additional management
system information later. For more information on
adding management systems, see the user documentation.
To add a management station:
Please enter the SNMP community string to be used.
[public]: public
NOTA:
Si se configura, el nivel de acceso predeterminado se establece en el valor
más alto disponible para la interfaz de administración SNMP. Inicialmente sólo se
activará SNMPv2. SNMPv3 se deshabilitará hasta que vuelva a configurar el
acceso de seguridad para SNMPv3 (por ejemplo, ID de motor, vista, etc.).
Guía de introducción
293