Connecting A Switch To A Terminal - Dell PowerConnect 7024 Handbuch Zum Einstieg

Connecting a Switch to a Terminal

After completing all external connections, connect a terminal to a switch to
configure the switch.
NOTE:
Read the release notes for this product before proceeding. You can
download the release notes from the Dell Support website at
support.dell.com/manuals.
NOTE:
We recommend that you obtain the most recent version of the user
documentation from the Dell Support website at support.dell.com/manuals.
To monitor and configure the switch via serial console, use the console port
on the front panel of the switch (see Figure 1-14) to connect it to a VT100
terminal or to a computer running VT100 terminal emulation software. The
console port is implemented as a data terminal equipment (DTE) connector.
The following equipment is required to use the console port:
• VT100-compatible terminal or a desktop or a portable computer with a
serial port running VT100 terminal emulation software, such as Microsoft
HyperTerminal.
• A serial cable (provided) with an RJ-45 connector for the console port and
DB-9 connector for the terminal.
Perform the following tasks to connect a terminal to the switch console port:
1 Connect the DB-9 connector on the serial cable to the terminal or
computer running VT100 terminal emulation software.
2 Configure the terminal emulation software as follows:
Select the appropriate serial port (for example, COM 1) to connect to
a
the console.
Set the data rate to 9600 baud.
b
Set the data format to 8 data bits, 1 stop bit, and no parity.
c
Set the flow control to none.
d
Set the terminal emulation mode to VT100.
e
20
Getting Started Guide