Herunterladen Inhalt Inhalt Diese Seite drucken

Unpacking Steps; Mounting The Switch; Installing In A Rack - Dell PowerConnect 7024 Handbuch Zum Einstieg

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 132
Getting Started Guide
Safety and Regulatory Information
Warranty and Support Information
Software License Agreement

Unpacking Steps

NOTE:
Before unpacking the switch, inspect the container and immediately report
any evidence of damage.
1 Place the container on a clean, flat surface and cut all straps securing the
container.
2 Open the container or remove the container top.
3 Carefully remove the switch from the container and place it on a secure
and clean surface.
4 Remove all packing material.
5 Inspect the product and accessories for damage.

Mounting the Switch

WARNING:
as well as the safety information for other switches that connect to or support the
switch.
The AC power connector is on the back panel of the switch.

Installing in a Rack

WARNING:
table or desk, or attach it to a wall.
CAUTION:
Disconnect all cables from the switch before continuing. Remove all
self-adhesive pads from the underside of the switch, if they have been attached.
CAUTION:
When mounting multiple switches into a rack, mount the switches
from the bottom up.
1 Place the supplied rack-mounting bracket on one side of the switch,
ensuring that the mounting holes on the switch line up to the mounting
holes in the rack-mounting bracket. Figure 1-11 illustrates where to mount
the brackets.
Read the safety information in the Safety and Regulatory Information
Do not use rack mounting kits to suspend the switch from under a
Getting Started Guide
15

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis