Technical Data; General Power Tool Safety Warnings; Work Area Safety - Parkside PEH 30 C3 Originalbetriebsanleitung

Technical data

Rated voltage:
Nominal output:
Rated idle
speed:
Plane width:
Cut depth:
Fold depth:
Protection class:
Noise and vibration data:
Noise measurement value determined in accordance
with EN 60745 . The A-rated noise level of the
power tool is typically as follows:
Noise emission value:
Sound pressure level:
Sound power level:
Uncertainty:
Wear hearing protection!
Total vibration value:
Handle:
Additional handle:
Uncertainty:
NOTE
► For an accurate estimate of the vibration load
during a specific working period, the periods
during which the appliance is switched off or
is running but not actually being used must
also be taken into consideration . This can
significantly reduce the vibration load over the
total working period .
► The vibration emission values and the noise emis-
sion values given in these instructions have been
measured in accordance with a standardised
test procedure and can be used for comparison
of the power tool with another tool .
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
PEH 30 C3
230 V ∼ 50 Hz (AC)
750 W
n 13000 rpm
0
82 mm
0–3 mm
max . 24 mm
II / (double insulation)
L = 96 .6 dB(A)
PA
L = 107 .6 dB(A)
WA
K = 3 dB
a = 10 .8 m/s
2
h
a = 8 .8 m/s
2
h
K = 1 .5 m/s
2
WARNING!
► Depending on the manner in which the power
tool is being used, and in particular the kind
of workpiece that is being worked, the vibra-
tion and noise emission values can deviate
from the values given in these instructions
during actual use of the power tool . Try to
keep the vibration loads as low as possible .
Measures to reduce the vibration load are,
e .g . wearing gloves and limiting the working
time . Wherein all states of operation must be
included (e .g . times when the power tool is
switched off and times where the power tool
is switched on but running without load) .
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions, il-
lustrations and specifications provided with
this power tool. Failure to follow all instruc-
tions listed below may result in electric shock,
fire and/or serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents .
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .
GB │ IE │ NI │ 3 ■