Replacing The Drive Belt (See Fig . E); Maintenance And Cleaning; Disposal - Parkside PEH 30 C3 Originalbetriebsanleitung

♦ Replace the planing blade
edges are blunt .
♦ Do not try to sharpen the planing blade
Turn the planing blade
NOTE
► Do not undo the two hex socket screws .
These are used for adjusting the height of
the cutter block . Adjustment is only required
if you are using a different type of planing
blade, e .g . a rustic blade .
When changing the blade, always replace
both blades to prevent an imbalance .
► First, unscrew only one blade . This will allow
you to orient your self on the factory-mounted
second blade when reassembling later .
♦ Use the supplied open-ended spanner
undo the 3 fastening screws for the planing
blade .
♦ Push the movable cutter block guard
the slot in the housing .
♦ Push the clamping element
the cutter block .
♦ Remove the tensioning plate
ing element . Remover the planing blade
from the clamping element
♦ Fit either a new or turned blade in the reverse
order .
♦ Planing blades can be purchased from the
address given below (see section "Service") .

Replacing the drive belt (see fig . E)

WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance .
♦ Remove the screws
belt cover .
♦ Remove the worn drive belt
♦ Fit the new drive belt
wheel first and then turn the drive belt
and pull it onto the large belt wheel
■ 8 │ GB │ IE │ NI
when both cutting
.
or replace it.
to
into
upwards out of
from the clamp-
20a
.
and detach the drive
.
onto the small belt
.
♦ Replace the drive belt cover
place using the screws

Maintenance and cleaning

WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance .
♦ Keep the appliance and the ventilation slits
clean to ensure fault-free operation .
♦ Clean the chip ejector
♦ To clean a blocked chip ejector, use a suitable
tool (e .g . a piece of wood, compressed air,
etc .) .
♦ Use a dry cloth to clean the housing .
♦ Use a brush to remove any dust stuck to the
appliance .
♦ Never use sharp objects, petrol, solvents or
cleansers which can damage plastic . Do not
allow any liquids to get into the interior of the
appliance .
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline .

Disposal

The packaging consists of environmentally
friendly material . It can be disposed of in
the local recycling containers .
Do not dispose of power tools in
your normal domestic waste!
European Directive 2012/19/EU requires that
worn-out power tools be collected separately and
recycled in an environmentally compatible manner .
Your local community or municipal authorities can
provide information on how to dispose of the ap-
pliance .
and fix it in
.
regularly .
PEH 30 C3