Replacing The Power Cable; Cleaning, Maintenance, Storage; Ordering Spare Parts And Transport - Parkside PKO 270 B2 Bedienungs- Und Sicherheitshinweise

Anleitung_LB7_4010406:_
GB/
CY
7.3 Fitting the air filter (15)
Remove the transportation stopper (B) and
screw the air filter (15) securely to the
equipment (Fig. 7, 8). Make sure that the intake
opening on the air filter faces down.
7.4 Changing the transportation cover (A)
Remove the transportation cover from the oil
filler opening (21) and insert the supplied oil
sealing plug (16) into the oil filler opening. (Fig.
9, 10.)
7.5 Mains connection
The compressor is equipped with a mains
■
cable with shock-proof plug. This can be
connected to any 230V ~ 50 Hz shock-proof
socket which is protected by a 16 A fuse.
Before you use the machine, make sure that
■
the mains voltage is the same as the
operating voltage (see the rating plate).
Long supply cables, extensions, cable reels
■
etc. cause a drop in voltage and can
impede motor start-up.
At low temperatures below +5°C,
■
sluggishness may make starting difficult or
impossible.
7.6 ON/OFF switch (Fig. 2)
Pull the ON/OFF switch (17) upwards to switch
on the compressor. To switch off the
compressor, press the ON/OFF switch down.
7.7 Setting the pressure (Fig. 1, 3)
Use the pressure regulator (4) to set the
■
pressure on the pressure gauge (6).
The set pressure can be drawn from the
■
quick-lock coupling (5).
The vessel pressure can be read off the
■
pressure gauge (3).
The vessel pressure is drawn from the
■
quick-lock coupling (20).
7.8 Setting the pressure switch (Fig. 1)
The pressure switch (2) is set at the factory.
Cut-in pressure approx. 6 bar
Cut-out pressure approx. 8 bar
12
24.02.2011 10:09 Uhr Seite 12
7.9 Fitting the compressed air hose
(Fig. 1, 3)
Use the compressed air hose (14) if you intend
to carry out work at a greater distance from the
compressor. To do so, connect the nipple (H)
on the compressed air hose to one of the quick-
release couplings (5, 20). Then attach the
compressed air tool to the quick-release
coupling (G) on the compressed air hose.

8. Replacing the power cable

If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer or its after-sales service or
similarly trained personnel to avoid danger.
9. Cleaning, maintenance,
storage, ordering spare parts
and transport
Important!
Pull out the power plug before doing any
cleaning and maintenance work on the
equipment.
Risk of injury from electric shock!
Important!
Wait until the equipment has cooled down
completely! Risk of burns!
Important!
Always depressurize the equipment before
carrying out any cleaning and maintenance
work (see 9.7.1)! Risk of injury!
9.1 Cleaning
Keep the equipment free of dirt and dust as
■
far as possible. Wipe the equipment with a
clean cloth or blow it down with compressed
air at low pressure.
We recommend that you clean the
■
equipment immediately after you use it.
Clean the equipment regularly with a damp
■
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be
aggressive to the plastic parts in the
equipment. Ensure that no water can get