Starting Up - Parkside PBH 1100 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Anleitung_4258375_FI_DK:_
Tighten the locking screw (4) again.
Now drill the hole until the depth stop (13)
touches the workpiece.
The depth stop (13) is notched to prevent it
from shifting when in use.
7.3. Tool insertion (Fig. 4)
Clean the tool before insertion and apply a
thin coating of drill bit grease to the shaft of
the tool.
Pull back and hold the locking sleeve (2).
Turn and push the dust-free tool into the tool
mounting as far as it will go. The tool will
lock automatically, after the locking sleeve
is released.
Check that it is properly secure by pulling
the tool.
7.4. Tool removal (Fig. 5)
Pull back and hold the locking sleeve (2) and
remove the tool.
7.5 Dust collection device (Fig. 8)
Slide the dust collection device (15) over the
drill bit before carrying out any hammer drilling
vertically above your head.
7.6 Fitting the quick-change drill chuck
(Fig. 4)
Clean the quick-change drill chuck (14)
before fitting it and apply a thin coating of
drill bit grease to the quick-change drill
chuck shaft.
Pull back and hold the locking sleeve (2).
Turn and push the dust-free quick-change
drill chuck (14) into the tool mounting as far
as it will go. The quick-change drill chuck
(14) will lock automatically after the locking
sleeve is released.
Check that it is secure by pulling the quick-
change drill chuck (14).
7.7 Removing the additional quick-change
drill chuck (Fig. 5)
Pull back and hold the locking sleeve (2) and
remove the quick-change drill chuck.
14.10.2011 12:21 Uhr Seite 13
7.8 Inserting the bit into the quick-change
drill chuck (Figure 6-7)
Important.
Always pull the power plug before making
adjustments to the equipment.
Release the depth stop (13) as described in
7.2 and push it towards the drill handle. This
provides free access to the chuck (14).
Open the chuck (14). The drill bit opening
must be large enough to hold the drill bit.
Select a suitable drill bit. Push the tool as far
as possible into the chuck opening.
Close the chuck (14). Check that the drill bit
is secure in the chuck (14).
Check at regular intervals that the drill bit or
tool is secure (pull the mains plug).

8. Starting up

Important!
To prevent all danger, the machine must
only be held using the two handles (3/6).
Otherwise there may be a risk of suffering an
electric shock if you drill into cables.
8.1 Status indicator (Fig. 1/Item 11)
The status indicator (11) lights up when the
power plug is connected.
8.2 ON/OFF switch (Fig. 9/Item 10)
First fit a suitable drill bit into the tool (see
7.3).
Connect the mains plug to a suitable
socket.
Position the drill in the position you wish to
drill.
To switch on:
Press the ON/OFF switch (10)
To switch off:
Release the ON/OFF switch (10)
Switching on continuous operation:
Secure the ON/OFF switch (10) with the
locking button (8).Important. It may only be
locked if the drill is set to rotate clockwise.
GB
13