Hitachi RB85E Bedienungsanleitung Seite 8

RB85E
Starting
CAUTION!
Do not start if the pipe is obstructed by the
ground or any other object.
1. Set ignition switch (1) to ON position.
(Fig. 2-2, 2C)
*Push priming bulb (4) several times so that
fuel flows through the bulb or return pipe.
(5) (If so equipped) (Fig. 2-3, 3B)
*Move throttle lever to a half-open position (2)
and look it with lock lever (4) (If so equipped),
when it is hard to start engine. (Fig, 2-2C)
2. Set choke lever to CLOSED position (4).
(Fig. 2-4)
3. Pull recoil starter briskly, taking care to keep
the handle in your grasp and not allowing it
to snap back. (Fig. 2-5, 5B)
4. When you hear the engine want to start,
return choke lever to RUN position (open).
Then pull recoil starter briskly again.
Fig. 2-2
Fig. 2-3B
Fig. 2-5B
NOTE!
If engine does not start, repeat procedures from
2 to 4.
5. After starting engine, allow the engine about
2-3 minutes to warm up before subjecting it
to any load.
Fig. 2-2C
Fig. 2-4
RB85E
G
B
Fig. 2-3
Fig. 2-5
GB-7