Handling - Conrad 97 60 14 Bedienungsanleitung

14. Handling

• Take note of all the safety instructions in these operating instructions!
• The product is only to be used in dry indoor locations. Contact with moisture
must be avoided by all means. Never touch the device and its plug-in power
supply when your hands are wet or damp. It can cause perilous electric shock!
• The following unfavorable conditions are to be avoided at the place of
installation or during transport:
- Wetness or too high air humidity
- extreme hot and cold temperatures
- direct sunlight
- dust or flammable gases, fumes or solvents
- strong vibrations
- strong magnetic fields such as near machines or loudspeakers
• When the product is brought from a cold into a warm room condensation may
form.
Let the photo bank and the plug-in power supply get to room temperature
first, before the devices are used or before connecting them with mains
voltage. This can sometimes take several hours.
Otherwise the photo bank and the plug-in power supply may get damage,
there is furthermore the risk of a mortal electric shock!
• When installing the device, make sure that no cables are pinched or caught.
• Check the product for damage before each use! If you notice any damage,
the plug-in power supply must not be connected with the mains voltage and
the photo bank must not be used!
• Safe operation must be presumed to be no longer possible, if
- the device exhibits visible damage,
- the device does not operate any longer and
- the device was stored under unfavourable conditions for a long period of
- the device was exposed to extraordinary stress caused by transport.
• Always only pull the plug-in power supply from the mains socket by the
gripping area provided on the side. Never pull the cable of the plug-in power
supply!
38
time or