Herunterladen Inhalt Inhalt Diese Seite drucken

Connection To Computer - Conrad 97 60 14 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

13. Connection to Computer

• Switch your computer on and wait until the operating system is completely booted.
• For Windows 98/98SE you install the driver first, if you have not done it already (see chapter
9), afterward you have to reboot.
For Windows ME/XP the driver must not be installed, since it is already an
integral part of the operating system.
• Connect the round low voltage plug of the plug-in power supply included in delivery with the
low voltage socket on the housing and insert the plug-in power supply into a mains socket.
Of course the photo bank also works without the plug-in power supply on the
computer. The power supply then is not via USB but via the built-in rechargeable
battery.
Use the plug-in power supply to save the rechargeable battery.
• Put the sliding switch on the side in the "ON" position. Afterwards switch on the photo bank
by pressing the " " button for longer period of time, if there is no display yet on the LC
display.
• Connect the housing via the USB cable included in delivery with a USB port of your computer.
• The display will show the following message:
• The existing partitions as well as the plug-in units of the integrated card reader are included
as additional drives.
Thus, you have direct access to the partitions (copy files to the computer or onto built-in hard
disk of photo bank) and also to the card reader.
This means that the card reader integrated in the product, can be used as a conventional
card reader for the reading and writing of memory cards!
37

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis