Connecting Inputs - Pioneer DJM-700-S Bedienungsanleitung

CONNECTIONS
Always turn off the power switch and disconnect the power plug from its outlet when making or changing connections.

CONNECTING INPUTS

Pioneer DJ CD players
The audio output connectors of a DJ-type CD player can be
connected to the CD input connectors (channel 1 or 2), or to the
LINE input connectors (channel 1) of the DJM-700-S/DJM-700-K.
Connect the control cord to the CONTROL jack, and set the input
selector switch to [CD] or [LINE].
Analog turntable
To connect an analog turntable, connect the turntable's audio
output cable to one of the channel 2 to 4 PHONO input
connectors. Set the corresponding channel's input selector switch
to [PHONO]. The DJM-700-S/DJM-700-K's PHONO inputs support
MM cartridges.
POWER
Analog turntable
6
En
CH-4
BOOTH REC PHONO LINE
L L
OFF
ON
1 GND 2 HOT
R R
MASTER1
3 COLD
R L
MASTER2
R L
Analog turntable
Connect the ground wire from an analog turntable to the
SIGNAL GND terminal of the DJM-700-S/DJM-700-K.
• Note that no PHONO input connector is provided for channel 1.
Connecting other line level output devices
To use a cassette deck or ordinary CD player, connect its audio
output connectors to one of the DJM-700-S/DJM-700-K's LINE
input connectors (channel 1, 3, or 4) or to the CD input connectors
(channel 1 or 2), and set the input selector switch to [LINE].
Input selector switch
CH-3 CH-2
PHONO LINE PHONO CD
L L
CONTROL
R R
SIGNAL GND
SEND RETURN
MASTER
R L R
(MONO)
ATT.
-6dB -3dB 0dB
DJ CD player
CH-1
LINE CD
L
MIC 2
CONTROL
R
DIGITAL OUT
MIDI OUT
L
(MONO)
fs(Hz)
48k 96k
CD player, etc.
DJ CD player Cassette deck, etc.