Midi Settings; Synchronizing Audio Signals To External Sequencer, Or Using Djm-700-S/Djm-700-Kinformation To Operate An External Sequencer - Pioneer DJM-700-S Bedienungsanleitung

MIDI SETTINGS

MIDI SETTINGS
MIDI is an acronym for "Musical Instrument Digital Interface" and
refers to a protocol developed for the exchange of data between
electronic instruments and computers.
A MIDI cable is used to connect components equipped with MIDI
connectors to enable the transmission and receipt of data.
The DJM-700-S/DJM-700-K uses the MIDI protocol for transmitting
data about component operation and BPM (timing clock).
DJ CD Player
OUT
BPM
=120
Audio
IN
DJM-700-S/DJM-700-K
MIDI sequencer
IN
BPM
=120
MIDI OUT
MIDI START
/STOP
TIME
SYNCHRONIZING AUDIO SIGNALS TO
EXTERNAL SEQUENCER, OR USING
DJM-700-S/DJM-700-K INFORMATION TO
OPERATE AN EXTERNAL SEQUENCER
1 Use a commercially available MIDI cable to connect the
DJM-700-S/DJM-700-K's MIDI OUT connector to the MIDI
sequencer's MIDI IN connector.
• Set the MIDI sequencer's synch mode to "Slave".
• MIDI sequencers that do not support MIDI timing clock
cannot be synchronized.
• Synch may not be achieved if the track's BPM cannot be
detected and measured stably.
• BPM values set with the TAP mode can also be used to
output the timing clock.
2 Press the MIDI START/STOP button.
• The MIDI timing clock output range is 40 to 250 BPM.
[MIDI Channel Setting]
The MIDI channel (1 to 16) can be set and stored in memory.
1 While holding the MIDI START/STOP button depressed, set
the power switch to ON.
• The display will show [CH SET] and the unit will enter the
MIDI setting mode.
2 Rotate the TIME dial to select the MIDI channel.
3 Press the MIDI START/STOP button.
• Records MIDI channel. During recording of channel, [SAVE]
indicator flashes.
• When recording of channel is completed, [END] is
displayed.
4 Set power to OFF.
21
En