Fader Start Function - Pioneer DJM-700-S Bedienungsanleitung

MIXER OPERATIONS
[Fader Curve Selection]
Select sound-volume curve corresponding to fader operation.
Use the CH FADER switch to select the desired channel fader
response curve.
• At the left setting, the curve operates to produce a rapid rise
as the channel fader approaches its distant position.
• At the right setting, the curve operates to produce an even,
neutral rise throughout the channel fader's movement.
• This setting applies equally to channels 1 to 4.
Use the CROSS FADER curve switch to select the cross fader
curve response.
• At the left setting, the curve produces a rapid signal rise. (As
soon as the cross fader lever leaves the [A] side, the [B]
channel sound is produced.)
• At the right setting, the curve operates to produce an even,
neutral rise throughout the cross fader's movement.
• At the middle setting, an intermediate curve is produced,
midway between the two curves noted above.
• This setting produces equal curve effects for both sides A
and B.

FADER START FUNCTION

By connecting the optional Pioneer DJ CD Player control cable,
the channel fader and cross fader can be used to start CD
playback.
When the mixer's channel fader lever or cross fader lever are
moved, the CD player is released from the pause mode and
automatically –and instantly – begins playback of the selected
track. Also, when the fader lever is returned to its original position,
the CD player returns to its cue point (back cue), thus allowing
"sampler" type play.
Cross fader start play and back cue play
When the CD player assigned to cross fader channel A is set to
standby at a cue point, moving the cross fader lever from the right
(B) side toward the left (A) side automatically starts play on the
channel A CD player.
When the cross fader lever reaches the left (A) side, the CD player
assigned to channel B goes to back cue (returns to cue point).
Also, when the CD player assigned to channel B is set to standby
at a cue point, moving the cross fader lever from the left (A) side to
the right (B) side automatically starts playback on the channel B
CD player. When the cross fader lever reaches the right (B) side,
the CD player assigned to channel A goes to back cue (returns to
cue point).
• The back cue is performed even if the input selector switch is not
set to [CD] or [LINE].
14
En
[Using the Channel Fader to Start Playback]
FADER
1
START
1, 2
2
4
1 Press the FADER START button for the channel (1, 2)
connected to the CD player you wish to control.
• The button for the selected channel lights.
2 Set the channel fader lever to "0".
3 Set the CD player to the desired cue point, and engage cue
point standby.
• If a cue point has already been set, it is not necessary to set
the CD player to standby at the cue point.
4 At the instant you wish to start playback, move the channel
fader lever.
• CD player begins playback.
• After playback has begun, if the channel fader lever is
returned to the [ 0 ] position, the CD player returns to the cue
point and re-enters standby mode (back cue).
• Playback control is possible with the channel fader only with the
CROSS FADER ASSIGN switch is set to [THRU].