C) Commissioning; Inserting The Batteries Into The Remote Control - Conrad 75 26 88 Bedienungsanleitung

c) Commissioning

☞
Commissioning is described below using an example.
Observe the Operating Instructions when connecting the screen.
• Switch on the radio receiver using the 'ON/OFF' key (7).
• Switch on the screen.
• The main screen of the radio receiver can be seen.

10. Inserting the Batteries into the Remote Control

• Press the clip on the back of the battery compartment to the side using your finger nail and pull
out the battery compartment downwards.
• Observing the correct polarity, insert a 3 V cell battery (type: CR2025) into the battery com-
partment holder.
• Slide the battery compartment holder, including the inserted batteries, back into the remote
control.
• The clip on the battery compartment must audibly engage.
☞
If the battery is already inserted in the remote control, remove the protective film.
Slide the battery compartment holder back into the remote control as described.
50