Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Radio Receiver - Conrad 75 26 88 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

b) Connecting the radio receiver
Place the radio receiver near to the screen but not on the screen. This could
interfere with the transmission.
The most favourable location is about 1 m to 2 m above the floor (for better
reception conditions).
- there must be a mains socket in the vicinity of the reception location.
• Connect the jack plug of the AV cable to the AV output (3) of the radio receiver.
• Connect the cinch plug of the AV cable to the cinch input on your screen (white plug = audio,
yellow plug = video).
• Connect the low voltage plug of the supplied power unit to the power supply (2) on your radio
receiver.
• Plug the power unit into a suitable mains socket.
• The radio receiver is now ready for use.
To avoid distortion or mismatching that could damage the device, the audio
connecting plug (white) may only be connected to an audio cinch input.
The video connector (yellow) may only be connected to an RCA video input.
If you are not clear about the correct connection, contact our technical support
or another specialist.
For any extension, only use the shielded cinch cables suitable for this. The use
of other cables could cause interference. Keep the length of the cable as short
as possible.
49

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis