Herunterladen Diese Seite drucken

Connection; Inserting/Replacing The Remote Control Batteries - Conrad 35 01 88 Bedienungsanleitung

Werbung

The speaker terminals can be opened pressing the red or black plastic nose. Put the
bared speaker wire into the terminal and release the plastic nose. The speaker wire
now is fixed and a good contact is ensured.
The speaker wire is two-colour red (+) and black (-). Connect the speaker terminals
of the main unit and those of the speakers with correct polarity.
Connection of the speaker wires
Speaker terminals
SPEAKER L red terminal
SPEAKER L black terminal
SPEAKER R red terminal
SPEAKER R black terminal
Mains connection:
• Plug the mains plug of the mains cable (22) into a common 230V AC / 50 Hz mains
socket.
Inserting/Replacing the Remote Control
Batteries
Do not leave batteries lying around as children or pets might swal-
low them! In case of batteries being swallowed, seek immediate
medical care! Leaking or damaged batteries might cause causti-
cization when in contact with skin; therefore, use suitable protec-
tive gloves! Do not short-circuit or try to recharge batteries! Do
not throw them into fire! Explosion hazard!
Do not leave the batteries in the remote control or in the system
respectively! Even leakage-protected batteries might corrode or
release chemicals which are noxious or can damage the battery
compartment! Remove the batteries from the battery compart-
ment in case you do not use the remote control for a longer period
of time.
Before initial installation of the system or if the system does not respond to the remo-
te control any longer or the range of the remote control is reduced, please replace
the batteries! The batteries can be replaced as follows:
• Open the battery compartment on the back of the remote control pushing the
cover of the battery compartment off the remote control in direction of the arrow.
• Insert two AA-size batteries with correct polarity.. The correct polarity is imprinted
on the remote control.
• Close the battery compartment.
42
speaker wires
red wire of left speaker
black wire of left speaker
red wire of right speaker
black wire of right speaker
Mettez le CD en place, le côté imprimé (face avec label) est de votre côté et la face
brillante est du côté de l'appareil.
Appuyez à nouveau la touche OPEN/CLOSE, le couvercle se referme.
L'appareil commence par lire les données du disque (nombre de titres, durée)
Lecture d'un CD
Appuyez sur la touche
PLAY / PAUSE pour faire démarrer la lecture.
Le display (affichage) indique le numéro du titre joué et le temps écoulé.
Régler le volume avec la touche
S'il n'y a pas de CD dans le compartiment, l'affichage indique:
71

Werbung

Kapitel

loading