Connection; A) Audio Connections On The Active Pa Speaker And Their Corresponding Functions - Renkforce 1377550 Bedienungsanleitung

10. Connection

Make sure that the connection cable is not pinched or damaged by sharp edges.
Inputs must only be connected to low-level audio outputs on an audio device. In addition,
outputs must only be connected to low-level audio inputs.
Input and output devices must be switched off when they are being connected to one another.
Only use shielded audio cables to connect the input and output devices. Unsuitable cables
may cause interference.
In order to avoid distortions or mismatches that could damage the product, only audio devices
with a jack or XLR output may be connected to the corresponding inputs. Only one audio
device with a Speakon
a) Audio connections on the active PA speaker and their corresponding
functions
Connection
AUX OUT cinch connection (1)
AUX IN cinch connection (2)
MIC MIC 1 MIC 2 XLR connection (3)
Jack connection (18)
SD card slot (5)
USB connection (6)
Speaker connection (22)
or jack socket may be connected to the 8 Ohm speaker output.
®
Function
Output for an analogue output signal (Line out)
Input for an analogue input signal (stereo)
Connection from one or two microphones
3.5 mm jack connection (Aux in analogue audio input for
mobile devices, e.g. iPhones)
Insert the SD cards in the correct orientation. Press the
SD card slightly to remove it from the slot.
USB socket for USB sticks
Speakon
impedance of up to 8 Ohms.
connection for a passive speaker with an
®
37