Herunterladen Inhalt Inhalt Diese Seite drucken

Initial Operation; Installation - Conrad 75 02 69 Bedienungsanleitung

Hochauflösende kamera mit ir-strahler
Inhaltsverzeichnis

Werbung

Switch the direct voltage source on.
Switch your TV set or the monitor on and the select the input to
which the camera is connected (such as AV input on the TV set).
The picture of the camera will appear on the screen.
In the unlikely event that no picture appears on the screen or
another malfunction occurs, immediately switch off the opera-
ting voltage and the TV set / monitor, and check once again by
using the "Troubleshooting" check list in these instructions.
If the image is not clear, the sharpness can be adjusted.
Please proceed as described in the following list:
Push the cover from the
Open the lens cover by
camera.
turning.
Pull the IR LED from the
Use a suitable screwdriver
housing
to undo the small screw
on the lens.
Proceed in reverse sequence to close the lens housing.
Please make sure that the housing is closed carefully. The lens
cover has to be well tightened to protect the camera against
moisture.
20
Carefully pull off the lens
seal.
Adjust the image sharp-
ness by turning the lens.
On account of the IR diodes installed which are switched on auto-
matically, excellent monitoring is ensured even in absolute dark-
ness. The range of the IR diodes is approx. 10 m.

Initial operation

In order to ensure proper commissioning, you should
read these operating instructions including the
safety instructions thoroughly and attentively before
using the system.

Installation

In choosing the location to set up your camera, please note that
direct intense sunlight, vibrations, dust, heat, cold, and moisture
have to be avoided.
The device must not be set up in the vicinity of other devices with
strong magnetic fields.
17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis