Attaching The Feet (See Fig. B); Attaching The Dust Blow Tube (See Fig. C); Bringing Into Use; Setting The Stroke Rate - Parkside PDKS 120 Bedienungs- Und Sicherheitshinweise

Assembly / Bringing into use
Attaching the feet
Q
j
Attach the feet
12
mounting holes in the device's base plate.
j
Place the plain washers and then the nuts on to
the screw threads.
j
Tighten the nuts using a size 10 open spanner.
Attaching the dust blow tube
Q
(see Fig. C)
j
Screw the dust blow tube
opening provided for it.

Bringing into use

Q
Take note of the mains voltage. The mains voltage
at the mains socket must match that shown on the
rating plate on the device. Devices marked with
230 V can also be operated at 220 V.
CAUTION! Make sure that the device is
switched off before you connect it to the mains supply.
J
Always switch on the electrical power tool before
moving the workpiece against it. Otherwise
there is the risk of kickback.
Setting up the device:
j
Grab the device at the position labelled "Bitte
hier anheben - Please lift here" to position the
device.
Switching on the device:
j
Press the green ON button
Switching off the device:
j
Press the red OFF button

Setting the stroke rate

Q
j
Turn the stroke rate controller
increase the stroke rate.
j
Turn the stroke rate controller
to decrease the stroke rate.
10 GB/IE
(see Fig. B)
12
from below through the
clockwise into the
1
.
4
.
3
clockwise to
2
anticlockwise
2
NOTE: Be aware that too high a stroke rate leads
to the saw blade heating up, an increase in wear
of the saw blade and burn marks on the material.
j
Select a saw speed suitable for the material
being sawn.
Maximum
speed
Thick woo- Straight
1
den board cut
Thin woo- Straight
den or and curved
plastic cuts
board
Tilting the saw table
Q
(see Figs. D, E)
j
Unscrew the angle setting screw
j
Tilt the saw table
reached.
NOTE: The angle can be read off the angle
scale .
6 a
j
Retighten the angle setting screw
Inserting / removing the
Q
saw blade
WARNING!
Pull the mains plug out of the socket before you
carry out any task on the device,
Inserting the saw blade
j
Lift up the clamping lever
j
Insert the saw blade
the saw table
Ensure that the teeth of the saw blade
forwards and downwards.
j
Suspend the saw blade
blade mount
j
Then hook the top pin of the saw blade
the recess provided for this purpose in the top
saw blade mount
Medium Minimum
speed speed
Normal -
fretsaw
work
Normal Intricate
and intrica- fretsaw
te fretsaw work
work
6
.
5
until the desired is
6
.
5
7
DANGER OF INJURY!
:
7
.
13
through the opening in
7
.
6
in the bottom
7
.
14
.
8
point
7
in
7