Changing The Fuse; Technical Data; Radio Range - Conrad 85 69 98 Bedienungsanleitung

Changing the fuse

You can change the display fuse without tools.
To do so, unscrew the front of the plug (3).
Replace the defective fuse with a new fuse of the same type and
rated voltage.
Carefully screw the plug on again.
Fuse type 3 A quick-acting/250 V (US standard)
Common name: F3A/250V
6.3 x 32 mm glass tube fuse

Technical Data

Operating voltage DC
Power input
Detection area
Viewing angle
Wireless connection range
Frequency of radio connection
Operating temperature
Dimensions (W x H x D)
Weight
Length of sensor cable

Radio range

The range depends on many different factors. In ideal conditions, the range can be up to 5m provided there
are no obstructions (between the two components).
A guarantee for this range is, however, not possible as the local conditions at the place of installation
could have a negative effect on the range.
A deterioration of the range is to be expected in the presence of the following:
• Electrical lines
• Devices on the same or next frequency
• Badly insulated electronic devices
• Sheet metal walls
10 - 15V (12V on-board supply net with negative pole earthed)
Control unit max. 24 mA
Display max. 160 mA (standby 25 mA)
30 to 200 cm
>60° (horizontal/vertical)
Approx. 5 m
433 MHz
-20 to +70?
Display 94 x 49 x 31mm
Control unit 99 x 72 x 26mm
display 120g
Control unit 85g
250 cm
.
29