Märklin 66470 Bedienungsanleitung Seite 14

Several feederTracks
On medium size and larger layouts power must be fed to the
track at several points. We recommend that you install a
feeder track every 2 to 3 meters (approx. 6 to 9 feet).
 Figure 2, page 58.
Several track circuits
In order to be able to control several locomotives separa-
tely, the layout must be divided into several track circuits
by installing third rail insulators (7522 for K track, 74030 for
C track). Each track circuit has its own 32 W Transformer
with at least one feeder track. Please be sure to observe
at all times the safety precautions given above when using
several transformers  Figure 5 and 6, page 60/61.
Connecting the 32 W Transformer to Märklin 1 Layouts
The 32 W Transformer is suitable for use only in dry areas
With Märklin 1 track the 5654 terminal clip set is used to
feed power to the track.  Figure 3, page 59
One 104 770 interference suppression set should be used
with each transformer used to operate trains.
Connecting Lights or Solenoid Accessories
Model railroad lights or solenoid accessories such as turn-
out or signal mechanisms are connected to the constant 16
volt AC current output on a transformer. All of the transfor-
mers described in these instructions have a pair of terminals
for this connection (yellow + brown terminal clips).
Model railroad lights in buildings and/or street lights are
connected directly to the yellow "L" terminal clip and brown
14
"0" terminal clip on the 32 W Transformer.
The diagram for connections for model railroad lights can be
found in Figure 4, page 59. The diagrams for connections for
a turnout mechanism or a signal mechanism can be found in
Figures 7 and 8, page 62/63.
Important: The model railroad lights or solenoid accessories
connected to the transformer must be rated for 16 volts AC
A light or solenoid accessory must never be
!
connected to two different transformers at the
same time.
If two solenoid accessories are connected to the same
circuit track or control box, then both solenoid accessories
must be powered from the same transformer.
3. Operations with the Transformer
Model railroad with one transformer: Plug the power cord
into a wall outlet.
Model railroad with several transformers: Plug the power
cords for the transformers into a power strip and plug the
power cord for the latter into a wall outlet. If you have a
power strip with an on/off switch, turn this on after having
carried out the steps above.
Operating Trains with the 32 W Transformer
The locomotive's speed is changed by turning the speed
control knob on the 32 W Transformer.
Turn to the right – the locomotive runs faster
Turn to the left – the locomotive runs slower
Turn to the left to the "0" setting – the locomotive stops.