Setting Up The Resolution - Conrad AT18 Wichtiger Hinweis

Inserting the card:
• Switch the sports camera off.
• Remove the "connection cover (screwed on)" (1).
• Slide the "SD memory card" (10) into the SD card slot" (9) until you can hear a
"clip" sound.
• Replace the "connection cover (screwed on)" (1).
When you have inserted an "SD memory card" (10) properly (and the camera is
switched on), the "LCD display" (4) shows a card icon in (in the lower left of the
"LCD display" (4)).
Removing the card:
• Switch the sports camera off.
• Remove the "connection cover (screwed on)" (1).
• Press onto the "SD memory card" (10) until you can hear a "clip" sound.
• Remove the "SD memory card" (10).
• Replace the "connection cover (screwed on)" (1).

12. Setting up the resolution

To set the desired resolution, the camera must be switched on.
• Press and hold the "MENU" button (5) for approx. 2 seconds.
• Press the
( 640x480,
• Briefly press the "MENU" (5) button to confirm the settings.
The factory settings for the resolution is
High resolution requires more memory space than low resolution.
Best image quality is achieved with a high resolution. Low resolutions
enable longer recording times.
"Trigger" (2)
320x240 pixels.
again to select
640x480 pixels.
the desired resolution
33