Sony TDG-BT500A Bedienungsanleitung Seite 7

To use the SimulView™ mode
SimulView™ allows two players to view independent screen images in full screen
while playing the same game on a shared screen. The image is displayed in 2D.
To use this feature, the game software and the TV must support SimulView™.
When using this mode, the Active 3D Glasses automatically change to
SimulView™ mode. Every press the button of the Active 3D Glasses can switch
between the players as follows.
 Mode: SimulView™ mode (Player 1)  SimulView™ mode (Player 2)
 Indicator: Green LED blinks every 2 seconds with SimulView™ mode (Player 1)  Yellow
LED blinks 2 times every 2 seconds with SimulView™ mode (Player 2)
To replace the battery
If the LED indicates low battery power
(indicator blinks green (yellow when
SimulView™ mode) 3 times every 2
seconds), replace the battery. Use a CR2025
battery only. Press the unlock button with
the tip of a pen, etc, and take out the
battery case, then replace the battery with a
new one. After that, be sure to lock the
battery case again.
Tips
 If you wear glasses, remove the nose pad
of the Active 3D Glasses by pulling it
down, then wear them over your glasses.
Notes
 Power off the Active 3D Glasses, when re-
register the glasses.
 The glasses turn off if you hold the power
button down for 2 seconds, or if no signal
from the TV is detected for more than 1
minute.
 3D effect or SimulView™ effect may be less
pronounced if ambient temperature is
low.
Unlock button
CR2025
(-) side
GB
GB
7