Alarm Function; Setting The Alarm Times - Conrad 67 20 72 Bedienungsanleitung

Manually setting the date and time
The product receives the DCF signal at a range of approx. 1500 km around Mainfl ingen near
Frankfurt on the Main from where it is transmitted.
Just like other radio transmissions (radio, television, remote controls, etc.) reception can be
disrupted. This can be caused by electric or electronic devices or metal components located in
the vicinity of the product.
Therefore, you can set the time and date manually instead of setting it automatically via DCF
signal.
• Hold down the "SET/WAVE" (3) button for about 3 seconds until the number 90 fl ashes in the
top line of the display.
• Press the "SET/WAVE" (3) button twice until the large date fl ashes in the centre of the display.
• You can change the value using the "+/-" (5) and (6) buttons. For quick adjustment, hold down
the button in the corresponding position a little longer.
• Press the "SET/WAVE" (3) button to set the current date. The month and date are set using
the "+/-" (5) and (6) buttons. The day of the week (Monday...Sunday) is calculated automati-
cally.
• Once the date is set, press the "SET/WAVE" (3) button again briefl y to save the settings and
set the time and hour format.
The default when the clock is used for the fi rst time is the 12-hour format.
• You can change the value required using the "+/-" (5) and (6) toggle keys.
• Once the time and the hour format is set, press the "SET/WAVE" (3) button again briefl y to
save the settings and fi nish the setting.

8. Alarm function

a) Setting the alarm times
• Press and hold the "ALARM" (4) button for about 3 seconds. The alarm time will illuminate at
the bottom of the display. The default time when the device is used for the fi rst time is "07:00".
• You can change the alarm time using the "+/-" (5) and (6) buttons. For quick adjustment, hold
down the button in the corresponding position a little longer.
• Press the "ALARM" (4) button again to save the alarm time.
24