Specifications - Hitachi CG 14SDL Bedienungsanleitung

◯ Make sure that any swarf and dust falling on the power
tool during work do not collect on the battery.
◯ Do not store an unused battery in a location exposed to
swarf and dust.
◯ Before storing a battery, remove any swarf and dust that
may adhere to it and do not store it together with metal
parts (screws, nails, etc.).
2. Do not pierce battery with a sharp object such as a
nail, strike with a hammer, step on, throw or subject the
battery to severe physical shock.
3. Do not use an apparently damaged or deformed
battery.
4. Do not use the battery in reverse polarity.
5. Do not connect directly to an electrical outlets or car
cigarette lighter sockets.
6. Do not use the battery for a purpose other than those
specifi ed.
7. If the battery charging fails to complete even when a
specifi ed recharging time has elapsed, immediately
stop further recharging.
8. Do not put or subject the battery to high temperatures or
high pressure such as into a microwave oven, dryer, or
high pressure container.
9. Keep away from fi re immediately when leakage or foul
odor are detected.
10. Do not use in a location where strong static electricity
generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears abnormal
during use, recharging or storage, immediately remove
it from the equipment or battery charger, and stop use.
CAUTION
1. If liquid leaking from the battery gets into your eyes,
do not rub your eyes and wash them well with fresh
clean water such as tap water and contact a doctor
immediately.
If left untreated, the liquid may cause eye-problems.
2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you fi nd rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using the
battery for the fi rst time, do not use and return it to your
supplier or vendor.

SPECIFICATIONS

POWER TOOL
Model
Pole type
Cutting capacity diameter
Rotation direction
No-load speed
Operating time on one charge *
(When supplied rechargeable battery is fully charged)
Battery
Weight (with nylon head, rechargeble battery and
cover)
*1 The data in the above table is provided only as an example. Since type of grass, ambient temperature, rechargeable
battery characteristics, work methods, etc. can vary widely the above should only be used as a rough guideline.
*2 Conditions: Outer diameter of nylon head 310 mm, switch set to full speed. (switch left ON all the time)
1
WARNING
If an electrically conductive foreign object enters the
terminals of the lithium ion battery, a short-circuit may
occur resulting in the risk of fi re. Please observe the
following matters when storing the battery.
◯ Do not place electrically conductive cuttings,
nails, steel wire, copper wire or other wire in the
storage case.
◯ Either install the battery in the power tool or store
by securely pressing into the battery cover until
the ventilation holes are concealed to prevent
short-circuits (See Fig. 1).
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe
the following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100Wh are considered to be in the freight classifi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
2 to 3 digit number
CG14DSDL
Straight type
310 mm
Counterclockwise as seen from above
5000 min
17 – 18 min*
2
BSL1430: Li-ion 14.4 V
(3.0 Ah 8 cells)
4.1 kg
English
Wh
CG18DSDL
-1
24 – 26 min*
2
BSL1830: Li-ion 18 V
(3.0 Ah 10 cells)
4.3 kg
13