Inserting/Replacing The Batteries; Safety Instructions - Conrad 67 15 90 Bedienungsanleitung

O P E R A T I N G I N S T R U C T I O N S
Binoculars with digital camara
Order no. 67 15 90 (2.0 Megapixel)
Order no. 67 15 91 (1.3 Megapixel)
Prescribed Use
The product can be used as conventional binoculars e.g. for nature-watching. As a special feature, the
product contains an integrated digital camera. The pictures can be transmitted to a computer via USB.
The camera has an installed memory (8MByte for order no. 671591 or 16 MByte for order no. 671590).
Furthermore, an SD memory card can be inserted (up to 2GByte) (SD memory is not included).
This product complies with the applicable national and European requirements. We kindly request the
user to follow the operating instructions, to maintain this condition and to ensure safe operation!
All names of companies and products are the trademarks of the respective owner. All rights reserved.
Included in package
• Binoculars with integrated digital camera
• Protective bag (with belt loop)
• USB cable
• Carrying strap (may come attached to the binoculars)
• CD with driver/software
• Cleaning cloth
• Operating Instructions
Controls
1 Rotating knob for focus setting
2 Miniature USB socket (underneath the
protective cover)
3 Ocular
4 Slot for SD memory card (underneath the
protective cover)
5 Battery compartment cover
6 LCD display
7 "MODE" key
8 "SET" button
9 Object lens
10 Camera lens
11 Tripod socket (on the bottom)
12 Connection for carrying strap

Safety Instructions

The warranty will be void in the event of damage caused by failure to observe these
safety instructions. We do not assume any liability for any consequential damage!
Nor do we assume liability for damage to property or personal injury caused by
improper use or failure to observe the safety instructions. The warranty will be void
in such cases!
• The unauthorised conversion and/or modification of the product is prohibited because
of safety and approval reasons (CE). Never dismantle the product. There are no serv-
iceable or adjustable parts inside the product.
• Maintenance, adjustment, or repair work must only be carried out by a specialist/ spe-
cialist workshop.
• The product is not a toy and must be kept out of the reach of children. The product con-
tains small parts, glass (display) and batteries.
• The product must not get damp or wet.
• Never look at the sun or other light sources with the binoculars, as this could damage
your eyes permanently. If you hand over the binoculars to a third party, inform the latter
of the dangers involved with such use.
• If you don't use the binoculars for a long period of time, keep them in their carrying case.
In unfavourable conditions, solar radiation can cause the lenses to react as a burning
glass, risk of fire!
• Do not expose the device to high temperatures for a long period. Overheating may dam-
age the display.
• Do not leave packing materials unattended. They may become dangerous playthings for
children.
• Handle the product with care; knocks, blows or even a fall from a low height can dam-
age it.
Notes on batteries/rechargeable batteries
www.conrad.com
• Keep batteries/rechargeable batteries out of reach of children.
• Make sure to insert the batteries/accumulators with the correct polarity.
Version 04/09
• Do not leave batteries/rechargeable batteries lying around; they could be swallowed by children or
pets. If swallowed, consult a doctor immediately.
• Leaking, or damaged batteries/rechargeable batteries, in contact with the skin can cause acid burns,
therefore, use suitable protective gloves.
• Batteries/rechargeable batteries must not be short-circuited, opened or thrown into a fire. There is a
risk of explosion!
• Conventional batteries must not be recharged. Risk of explosion!
• Never mix batteries and rechargeable batteries; do not mix batteries or rechargeable batteries with
different charges (e.g. full and half-full batteries). Always use two batteries / rechargeable batteries
of the same type and manufacturer.
• If you donít use the product for a long period of time (one week or longer), remove the inserted bat-
teries/rechargeable batteries.

Inserting/replacing the batteries

Open the battery compartment (5) on the underside of the binoculars. Insert two batteries of the type
AAA (Micro) observing the correct polarity. The respective figure in the battery compartment will help
you to do this (positive/+, negative/-). Close the battery compartment.
A change of batteries is necessary if the product cannot be switched on any more.
Conventional functions of the binoculars
Spectacle wearers may turn down the rubber caps of the oculars (3); one of the oculars can be adjust-
ed to different eye dioptres (observe imprint "+" and "-" on the rubber cap).
The distance between the eyes can be adjusted by moving the two halves of the binoculars.
Focussing can be done with the rotating scroller (1) on the upper side of the binoculars.
Inserting a memory card
The internal memory (8MB for order no. 671591 resp. 16MB for order no. 671590) is not fully available
because one part is needed for internal processes (buffering, image calculation and so on).
Alternatively, you may insert a SD memory card (not included in delivery) into the slot (4) (SD memo-
ry card with max. 2 GB, no SDHC memory card!).
Slide the memory card in such a way into the insert that the contacts of the memory card point upwards
(towards the rotary knob) with the small slanted corners first.
Basic functions of the camera
Switching On/Off
• Keep the button "MODE" pressed until a notification appears in the LC display; a beep is emitted.
• To turn off the device press the "MODE" botton shortly until "OFF" appears in the display, then press
the key "SET".
Select a function
Press the key "MODE" briefly to choose between the different functions (see chapter "Description of
the menu functions" below). With the "SET" button you can confirm the function.
Record picture
Press the key "SET" briefly. While saving the image no new photo can be taken (the message "Act"
appears in the display). The digital message of the LC display indicates the number of pictures taken.
Description of the menu functions
Press the "MODE" key briefly to choose between the different functions; the selection/confirmation is
done by briefly pressing the "SET" button.
This, however, erases the data/pictures from the internal memory. Transfer the images to
a computer before removing the batteries. Pictures on an inserted SD memory card will
not be erased when removing the batteries/rechargeable batteries.
The use of rechargeable batteries is possible, but due to their lesser voltage (battery =
1.5V, accumulator = 1.2V) and the reduced capacity, their operating period is shorter.
A battery symbol indicates the state of the inserted batteries or rechargeable batteries.
Turn the product off prior to inserting or removing the memory card! The internal memory
is unavailable and is available again only when no SD memory card is inserted.
If the device is connected to a computer via USB, the camera functions are disabled.
If no button is pressed the digital camera turns off automatically in order to save power.
Setting up the resolution
Press briefly on the "MODE" button until "HI" or "LO" flashes. Press the "SET" key to switch
between "HI" (high resolution) and "LO" (low resolution).
High resolution: Item-No. 671590:
Item-No. 671591:
Low resolution: 640 x 480 pixels
1600 x 1200 pixels
1280 x 1024 pixels