Initial Setup - Pioneer VSX-1122-K Kurzanleitung

Initial Setup

Before you start
1
Put the batteries in the remote control.
The batteries included with the unit are to check initial
operations; they may not last over a long period. We
recommend using alkaline batteries that have a longer life.
2
Switch on the receiver and your TV.
ALL ZONE STBY
RECEIVER SOURCE
DISCRETE ON
RCU SETUP
BDR
BD DVD DVR HDMI
3
Switch the TV input so that it connects to the
receiver.
4
Turn the subwoofer on and turn up the volume.
WARNING
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or catch
fire. It can also reduce the life or performance of batteries.
CAUTION
• When disposing of used batteries, please comply with
governmental regulations or environmental public institu-
tion's rules that apply in your country/area.
Canceling the demo display
The display on the front panel shows various information (demo
displays) when the receiver is not operating.
You can turn off the demo display.
l "Canceling the demo display"
• The demo mode is canceled automatically when the Auto
MCACC setup is performed (see below).
Automatically setting up for surround sound (MCACC)
The Auto Multi-Channel Acoustic Calibration (MCACC) setup
uses the supplied setup microphone to measure and analyze
the test tone that is outputted by the speakers. This setup
enables automatic high precision measuring and settings;
utilizing it will create an optimum user listening environment.
Important
• Measure in a quiet environment.
• If you have a tripod, use it to place the microphone so
that it's about ear level at your normal listening position.
Otherwise, place the microphone at ear level using a table
or a chair.
• Accurate measurements may not be possible if there are
obstacles between the speakers and the listening position
(microphone).
• When measuring, step away from the listening position,
and operate using the remote control from the external
side of all the speakers.
1
Connect the supplied setup microphone.
CONTROL ON / OFF
MCACC
SETUP MIC
Microphone
Tripod
The Full Auto MCACC screen appears on your TV.
1a.Full Auto MCACC
A/V RECEIVER
Speaker System : Normal(SB/FH)
EQ Type : SYMMETRY
MCACC : M1.MEMORY 1
THX Speaker : NO
START
Exit Return
2
Press on the remote control, then
RECEIVER
press the ENTER button.
• Automatic measuring will start.
• Measuring will take about 3 to 12 minutes.
3
Follow the instructions on-screen.
• Automatic setting is complete when the Home Menu
screen appears.
HOME MENU
A/V RECEIVER
1. Advanced MCACC
2. MCACC Data Check
3. Data Management
4. System Setup
5. Network Information
6. Operation Mode Setup
Exit Return
4
Make sure the setup microphone is
disconnected.
• Attach the front cover as shown in the following
illustration.
1
2
iPod
iPhone USB
iPad
Canceling the Auto Power Down
If no operation is performed for a certain amount of time with
no audio or video signal being input, the receiver's power turns
off automatically. The automatic power-off timer is set to 30
minutes under factory settings, and the timing can be changed
or the power-off function switched off altogether.
l
"Auto Power Down"
5