Conrad BT-FSE 2 Bedienungsanleitung Seite 4

d) Mounting on the sun screen
• Fasten the hands-free set on the rear side with the help of the wire clamp e.g. on the sun screen of your
vehicle. Do not use any force as otherwise, damage is possible.
The microphone should point directed towards you, so that a trouble-free speech transfer can be
guaranteed.
e) Accept call
• On receiving a call, the hands-free set emits a call tone via the integrated loudspeaker (1).
• To accept the call, press the " " (6) button. The LED (3) starts flashing during the call.
• To reject the call, hold the " " button (6) down for 2 seconds till an acoustic signal is output.
f) Make a call
• If you want to make a call, you can do this as usual via your mobile phone. The LED (3) on the hands-free
set flashes during a call.
g) End call
• To end a currently active call, press the "
h) Redial
• If you hold the "+" (4) down for 2 seconds, the mobile phone selects the last called number again.
The Redial function must be activated in your mobile phone for this.
i) Select the telephone number via voice input
This is possible only if your mobile phone supports this function. Observe the operating instruc-
tions of your mobile phone.
• Press the " " button (6) briefly and speak out the name of the desired subscriber.
• The mobile phone selects the number of the saved subscriber.
j) Adjust volume
• When talking on the mobile phone, adjust the desired volume of the audio rendition via the loudspeaker
with the help of the "+" (4) and "-" (5) buttons.
"+" = Increase volume
"-" = Decrease volume
k) Mute microphone
• When talking on the mobile phone, you can mute the microphone by holding the "MUTE" button (2) located
laterally on the edge down for 2 seconds.
• End the Mute mode by pressing the "MUTE" button (2) for 2 seconds again.
Safety fuse replacement in the cigarette lighter adapter
The cigarette lighter adapter has an internal safety fuse. If the safety fuse trips (e.g. after a short-circuit at the
USB connector), it can be replaced as follows:
• Turn the plastic knurled screw to the left in the clockwise direction, till the front section with the contact pin
can be removed.
• Take the safety fuse out and replace it with a safety fuse of identical design (micro fuse 5 x 20 mm, 250 V,
F 1 A; fast tripping characteristic).
• Place the front section containing the contact pin and turn the plastic knurled screw to the right in the clock
wise direction.
A defective safety fuse should not be bypassed. Never use a safety fuse with higher current or
other tripping characteristics. It can lead to fire!
Cleaning
A dry, soft and clean cloth is sufficient for cleaning the hands-free set. Do not apply too much pressure,
it can scratch the product. Do not use any aggressive cleaning agents, as otherwise the surface may get
discoloured.
Dust can be removed easily with a soft, clean brush and a vacuum cleaner.
" button (6) briefly.
Disposal
a) General instructions
Dispose of the product when it is no longer serviceable in accordance with the applicable legal
statutes.
Remove the rechargeable battery and dispose of it separately from the product. Paste the
rechargeable battery contacts with a strip of insulation tape to avoid short-circuit.
b) Batteries and rechargeable batteries
As the end user, you are required by law (Battery Ordinance) to return all used batteries/rechargeable
batteries; disposal of them in the household waste is prohibited!
Contaminated batteries/rechargeable batteries are labelled with these symbols to indicate that
disposal in the domestic waste is forbidden. The designations for the heavy metals involved are:
Cd = Cadmium, Hg = Mercury, Pb = Lead.
Used batteries, rechargeable batteries as well as coin cells can be returned to collection points in your
municipality, our stores or wherever batteries/rechargeable batteries/coin cells are sold.
You therefore fulfil your statutory obligations and contribute to the protection of the environment.
Declaration of Conformity (DOC)
We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this product con-
forms to the fundamental requirements and the other relevant regulations of the directive 1999/5/EC.
The Declaration of Conformity for this product can be found at www.conrad.com
Technical Data
a) Hands-free set
Bluetooth version .........................V2.1+EDR, Class II, range up to 10 m
Bluetooth profile ...........................HSP V1.2, HFP V1.5, A2DP V1.2
Pairing password .........................0000
Voice transmission .......................Full duplex
Rechargeable battery ..................Lithium-Ion, 3,7 V, 750 mAh
Charging socket ...........................Mini-USB, 5 V/DC
Charging duration ........................approx. 2 - 3 h
Duration of operation ................... Standby up to 800 h, talk time max. approx. 7 - 7.5 h; depending on the
mobile phone and the Bluetooth connection as well as the ambient tem-
perature
Dimensions ..................................123 x 46 x 15 mm (L x B x H, without retaining clamp)
Weight .........................................43.5 g (without rechargeable battery) or 61 g (with rechargeable battery)
b) Cigarette lighter adapter
Operating voltage ........................12 - 24 V/DC
Output ..........................................5 V/DC, max. 500 mA
Safety fuse ...................................micro fuse 5 x 20 mm, 250 V, F 1 A (swift tripping characteristic)
Cable length ................................approx. 1.2 m
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited. This publication represent the technical status at the time of
printing.
© Copyright 2014 by Conrad Electronic SE.